TDS Application Notes
1) Shake the lacquer can and add the hardener component. Immediately shake the mixture vigorously for 1 minute. Use the mixture directly or at least within 4 hours. If mixing smaller quantities of lacquer, then one section on the hardener bottle corresponds to 1 litre of lacquer. 2) Apply using a Bona Roller or Swivel Head Applicator at 8–10 m²/L (≈100–120 g/m²). Roll alternately across and with the grain of the wood avoiding accumulations of product. Always maintain a “wet edge” to avoid overlaps. 3) Allow to dry properly before applying further coats. Ensure proper ventilation. 4) If necessary, make an intermediate sanding using the Bona Scrad System P150 grit (or finer) and remove dust before applying a final layer of lacquer. Note: If the previous layer of lacquer/primer has been allowed more than 24 hours drying time then an intermediate sanding is always required. Light foot traffic can be resumed after 8 hours, but the surface remains susceptible to scratching and marring until fully cured. Full cure is achieved after approximately 7 days. Do not cover or damp mop the surface until fully cured.