TDS Application Notes
1) Shake the lacquer can and add the hardener component. Immediately proceed to shake the mixture vigorously for 60 seconds. Use the mixture within 3 hours. If mixing smaller quantities of lacquer, then one section on the hardener bottle corresponds to 1 litre of lacquer. 2) Apply using a Bona Roller at 8–10 m²/L (≈100–120 g/m²). Roll alternately across and with the grain of the wood avoiding accumulations of product. Always maintain a “wet edge” to avoid overlaps. 3) Allow to dry properly before applying further layers. Ensure proper ventilation. 4) If necessary, make an intermediate sanding using the Bona Scrad System P150 grit (or finer) and remove dust before applying a final layer of lacquer. Note: If the previous layer of lacquer/primer has been allowed more than 24 hours drying time then an intermediate sanding is always required. Floor will take light foot traffic approximately 6 hours after the final application and may be put into full use after 12 hours. Allow the surface to dry for at least 3 days before covering with carpets or other floor coverings. Also avoid placing heavy objects and avoid damp mopping the floor during this time. Note: If Traffic HD Anti-slip has been combined with Bona Craft Oil 2K then the surface must be allowed to cure for 1 week before the surface is covered.