TDS Application Notes
1) Shake the can vigorously for 1 full minute. 2) Apply using a Bona Roller at 8–10 m²/L (≈100–120 g/m²). Roll alternately across and with the grain of the wood, avoiding accumulations of product. Always maintain a “wet edge” to avoid overlaps. 3) Allow to dry properly before applying further layers. Ensure proper ventilation. 4) Make an intermediate sanding using the Bona Scrad System P150 grit (or finer) and remove dust before applying the final layer of lacquer. Note: If any previous layer of lacquer/primer has been allowed more than 24 hours drying time, then an intermediate sanding is always required before the following layer is applied. Light foot traffic can be resumed after 8 hours; however, the surface remains susceptible to scratching and marring until it is fully cured. Under normal conditions, the coating achieves 80 % cure after 24 hours and full cure after approximately 5 days. Do not cover or damp-mop the surface until fully cured.
